Below is the pin-out of the prewired control cable.įinally, the Power Connector is where you will wire up your motor. Plug the other end of it into the MachMotion IO6 Breakout Board (Figure 3). The Control Connector should be wired up when you receive your stepper drive. ![]() ![]() For more information see the section titled Configuration Switch on. The Configuration Switch allows you to easily configure the drive to your particular motor. The drives are wired using simple screw terminals as shown in the picture below. This document will give you all the information you need to connect your motors to your drives. The MachMotion micro-stepping drive is used to control all different types of stepper motors. ![]() For all information pertaining to the 8AMP please see this manual: KL11080 1 Overview WARNING! This information only applies to the 6AMP model.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |